Label can be removed and reapplied multiple times before losing its stick. You can easily clean Sharpie off of the label by using a small amount of isopropyl/rubbing alcohol on a paper towel or q-tip Expo brand Vis-á-Vis wet erase pens will also work, but are more prone to wipe off Ultra Fine Tip Sharpies seem to work the best for clear and legible labels Write your labels before peeling the decal off of the backing If you need less than five labels, you can purchase individual labels from our single label listing: The second image is simply an example for possible labeling. The white area of the labels do not come pre-filled or with any markings on them. The adhesive used is strong enough to ensure the label will stay affixed, but not so strong that the decal is hard to remove or damage the unit's faceplate* They are made out of a PVC Vinyl with an adhesive backing and have a satin laminate finish to ensure durability and minimal glare. I can remove the labels and rubber cement residue easily later.This is a listing for a 5-Pack of peel-and-stick patch bay labels compatible with the Behringer PX3000 and PX2000 patch bays. I attach the labels to my patchbay using rubber cement. Then drill the holes in the label, using the backing material for support. Start by clamping piece of rigid backing material to the table (I used a scrap piece of FR4 fibreglass circuit-board material). A regular twist drill will just tear the paper. For punching out the holes, I use a 7/16″ Forstner drill bit in my drill press. I print the labels on my inkjet using photo paper, mainly for the extra stiffness compared to plain paper.Īt this point, you can either cut out just the two label strips and attach them to your patchbay, or you can punch out the holes for the jacks and attach the entire faceplate at once. They’re kinda cryptic, I guess, but clear enough to me. I also created some icons to represent the “normalled”, “half-normalled”, “parallel” and “thru” patchbay configurations. You can optionally use Format/Borders and Shading to colour the cells. To use it, just click in the table cell above or below the jack, and type in the label. It actually fits two complete faceplates on one page. To fit on 8.5″x11″ paper, I split it onto two lines. It is basically an image of the front of the patchbay that I captured from Behringer’s PDF documentation, with a Word table overlayed on it. And here it is filled out with my own current configuration.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
January 2023
Categories |